Here's the steps it took to tie these down without knotting the needle or the threader when working on them.
Took awhile to figure out the steps but when it finally worked out they went smoothly to install and not get all tangled up when doing them.
The first step: Material
Second step: Threading the loop and the needle properly.
Third step: Threaded properly.
Step four: Ready for hammock install.
Step five: Sewing from top started.
Step six: Pulling threw for nail mount setup and needle removal.
Step seven: Needle removal and tie loop setup with tight nail mount.
Step eight: Loop behind nail mount for double knot tie off.
Step nine: Back tie off for loop with tight pull up for securing main knot tie off.
Step ten: Tight knot tie down completed.
Step eleven: Apply maxi cure ca and cut excess off, finished tie down detail. Then repeat steps all over again for next tie down.
As we know it takes slow movements and a gentle touch as not to strip the soft cotton or the thread when doing these type of tie downs. I am very satisfied with the outcome and have completed all of them. Moving on for rigging and mast install, will post images when I get the fore mast installed as it will be plastic and wood which will need to be painted and prep for rigging.